• 0 item(s)
    Your cart is empty!
Manual pusher system

Manual pusher made of clear plastic, consisting of four parts: the sliding rail (SPP 746-4545/380), backrest (SAP 328-4545), accessory for backrest (SPP 906-4545) and rod (SPP 905-4545/380). It is recommended for thin products wanted to be displayed in a slightly inclined position and where a pusher is often too weak to effectively push or too strong, and the products are damaged. The backrest is fixed on the sliding rail and the sliding rod inside the rail, operated by pulling, brings to the front of the shelf the products" backrest that will evolve in stages. Thus, the products on the shelf will always be visible. For higher volume products, the accessory is fixed on the backrest, increasing its efficiency and creating an ideal balance, not allowing the products to fall.

Sortieren nach
MANUAL PUSHER, 465 MM LENGTH, MADE UP OF 3 PARTS FOR SHELFS WITH 485 MM DEPTH

MANUAL PUSHER, 465 MM LENGTH, MADE UP OF 3 PARTS FOR SHELFS WITH 485 MM DEPTH

2,86 € 2.86 EUR
0
MANUAL PUSHER MADE UP OF 3 PARTS FOR SHELFS WITH 385 MM DEPTH

MANUAL PUSHER MADE UP OF 3 PARTS FOR SHELFS WITH 385 MM DEPTH

2,86 € 2.86 EUR
0
SLIDING PROFILE, 42 MM WIDTH, 435 MM LENGTH

SLIDING PROFILE, 42 MM WIDTH, 435 MM LENGTH

1,80 € 1.8 EUR
0
SLIDING PROFILE, 42 MM WIDTH, 335 MM LENGTH

SLIDING PROFILE, 42 MM WIDTH, 335 MM LENGTH

1,40 € 1.4 EUR
0